Small losses move the programme

A loader that cannot reach high enough carries the material in two trips. A machine that is too large for the site waits for room to manoeuvre. Neither stops the work, but each costs a few minutes on every lift. Repeated over weeks, those minutes turn into days on the programme.

That is why choosing equipment is a planning decision before it is a rental decision.

What to look at when choosing

  • Load and reach. The heaviest piece, the highest point and the longest distance. A machine is chosen for the hardest task, not the average one.
  • Ground and space. Ground bearing condition, slope, turning area and the size of gates and passages.
  • Duration. The days the machine will actually work on site. A machine standing idle is also a cost.
  • Operator. The competence and papers of the person operating the machine matter as much as the machine itself.
  • Backup. What replaces it when it breaks down, and how quickly.

Certificates and documents are completed before dispatch

A machine that arrives with missing documents waits at the gate. Periodic inspections, conformity documents and the additional requirements of the client or the country vary from job to job. The right approach is to draw up this list before mobilisation and send the equipment with its documents complete.

All equipment HYK sends to site is certified. Any additional documents and certificates a project requires are completed before dispatch.

A breakdown plan is part of the job

Every machine breaks down one day. The difference lies in how long it stops the work. When the response time of the service crew, spare parts and replacement options are discussed before the work begins, a breakdown is measured in hours. When they are not, it is measured in days.

In short

The right equipment is not the largest or the newest. It is the equipment that can do the hardest task on the site, fits the space, has its documents complete and can be replaced quickly when it fails.